Yuhong Holding Group Co.,LTD
ASTM A179 and ASTM A192 are both seamless cold-drawn carbon steel tube standards built on the same low-carbon chemistry, and most mills — Yuhong Group included — routinely produce dual-certified A179/A192 heats. They are still not interchangeable in a specification review, because they were written for two different services: heat transfer and high-pressure steam generation.
| Item | ASTM A179 | ASTM A192 |
|---|---|---|
| Official scope | Seamless cold-drawn low-carbon steel heat exchanger and condenser tubes | Seamless carbon steel boiler tubes for high-pressure service |
| Primary duty | Heat transfer — shell and tube exchangers, condensers, coolers, heaters | Steam generation — boiler banks, economizers, waterwalls, superheater supports |
| Carbon / manganese | 0.06–0.18% C, 0.27–0.63% Mn | 0.06–0.18% C, 0.27–0.63% Mn |
| Tensile strength | 47 ksi (325 MPa) minimum | 47 ksi (325 MPa) minimum |
| Yield strength | 26 ksi (180 MPa) minimum | 26 ksi (180 MPa) minimum |
| Hardness ceiling | 72 HRB maximum | 77 HRB maximum |
| Typical minimum wall in common service | About 0.065 in (1.65 mm) and up | About 0.085 in (2.2 mm) and up, heavier walls normal in boiler duty |
| Delivery condition | Cold drawn, annealed, pickled | Cold drawn, annealed, pickled |
| Typical sizes in service | 19.05 × 1.65 mm, 19.05 × 2.11 mm, 25.4 × 2.11 mm | 50.8 × 3.0 mm and heavier walls |
Wall ranges overlap in the middle of the size span and have shifted between editions. Confirm the figures against the current ASTM edition and your project specification before fixing a wall thickness.
Yuhong Group cold-draws A179 and A192 tubes from killed low-carbon steel on multi-roll and pilger lines, with 100% eddy current testing, hydrostatic testing, flattening and flaring as standard. We supply straight lengths up to 19.25 m, U-bend and square-bend tubes with post-bend heat treatment, and dual-certified material with EN 10204 3.1 certificates and full heat traceability. Typical orders run from a few hundred pieces for a single bundle to several hundred tonnes for refinery and power plant projects.
Send us your exchanger or boiler datasheet — grade, OD × wall, length, bend configuration and inspection requirement — and our engineers will confirm the correct standard, delivery condition and test package within one working day.
Yes. Both standards sit on the same low-carbon chemistry, so mills routinely certify one heat to A179 and A192 together. Dual certification is common for stockists and for projects that want a single heat number across exchanger and boiler packages.
72 HRB maximum, against 77 HRB for A192. The tighter ceiling exists so the tube can be rolled and U-bent without cracking. Tube measuring above 72 HRB is normally re-annealed before bending.
Not as a pressure part under A192 scope. Boiler waterwalls and economizers call for A192 or A210, whose minimum walls and test pressures match steam service. In boilers, A179 is generally limited to low-pressure, non-fired duties.
About 0.085 in (2.2 mm) in common service, with heavier walls normal in boiler duty; A179 is supplied down to roughly 0.065 in (1.65 mm). The ranges overlap, so confirm the current ASTM edition and your project specification before fixing a wall.
![]()
![]()
Contact Person: Mr. Jikin Cai
Tel: +86-13819835483
Fax: 0086-574-88017980