Yuhong Holding Group Co.,LTD
An RFQ for “stainless steel tube” only becomes a real enquiry once the standard is fixed. ASTM A213, A269 and A312 carry the same TP304 and TP316 chemistry, yet they were written for different equipment, test regimes and levels of quality assurance. Quoting to the wrong one is among the most expensive mistakes in this business.
| Item | ASTM A312 | ASTM A213 | ASTM A269 |
|---|---|---|---|
| Product form | Pipe | Tube | Tube |
| Design duty | High-temperature and corrosive piping | Boiler, superheater, heat exchanger | General corrosive service |
| Typical size range | NPS 1/8″ to 30″ | 1/8″ to 5″ heat exchanger sizes | 1/8″ to 2″ instrumentation sizes |
| Wall thickness basis | Schedule / average wall | Minimum wall | Average wall, minimum wall on request |
| Dimensional reference | ASTM A999/A999M | ASTM A1016 | ASTM A1016 |
| Nondestructive testing | Hydrostatic or NDT per A312 | Hydrostatic, eddy current or ultrasonic | Hydrostatic or eddy current when specified |
| Hardness control | Austenitic grades: hardness ceiling applies; ferritic grades: per grade | All grades, ferritic and austenitic, with grade-specific ceilings | Not normally specified |
| Grain size control | Not controlled | Required for H grades such as 304H and 316H — ASTM No. 7 or coarser | Not controlled |
| Typical end use | Process piping, headers, manifolds | Heat exchanger bundles, superheaters | Instrumentation, hydraulic lines, food and pulp service |
| Your equipment | Standard to specify | Controls you must verify |
|---|---|---|
| Tube bundle — rolled or expanded into a tubesheet | ASTM A213 | Hardness ceiling on all grades; grain size ASTM No. 7 or coarser on H grades |
| Process piping — butt-welded | ASTM A312 | Dimensional tolerances per A999/A999M; butt-weld compatibility with ASME B16.9/B16.25 |
| Instrument and small-bore fluid lines | ASTM A269 | Cleanliness, concentricity, coil length consistency; no hardness or grain-size requirement |
Yuhong Holding Group has manufactured stainless, duplex, nickel-alloy and alloy-steel tubular products since 2007, exporting 80–90% of output to oil and gas and power generation customers. Every shipment leaves with an EN 10204 3.1 certificate, full heat-number traceability and third-party inspection by SGS, BV, TÜV or Lloyd’s on request.
Send your datasheet — grade, OD × wall, length and destination — and we confirm the correct standard within one working day
Only if the purchase specification accepts it. A269 has no hardness ceiling and no eddy current requirement unless you add one, so most exchanger datasheets call A213 instead. For low-pressure, non-severe duty some buyers accept dual-certified A269/A213 tube.
Generally no. A312 is a pipe standard with schedule-based wall and butt-weld tolerances, while bundles need minimum-wall tube, hardness ceilings and grain-size control on H grades. Use A312 for the shell and channel.
0.04–0.10% carbon, with grain size controlled to ASTM No. 7 or coarser. The H designation is about creep strength at elevated temperature, not corrosion resistance, so both the carbon range and the grain size must appear on the certificate.
![]()
![]()
![]()
Contact Person: Mr. Jikin Cai
Tel: +86-13819835483
Fax: 0086-574-88017980