Yuhong Holding Group Co.,LTD
Every year, containers of stainless steel tube are rejected at destination for a reason that has nothing to do with quality: the material was manufactured to one specification and inspected against another. The buyer ordered 316L heat exchanger tube, the mill shipped ASTM A312 pipe, the inspector applied EN 10216-5 criteria, and the shipment failed on wall thickness. Understanding where these standards diverge is the cheapest risk control available to any importer.
| Specification | Product form | Wall thickness basis | Typical application |
|---|---|---|---|
| ASTM A312 | Seamless and welded austenitic pipe | Average wall, plus or minus 12.5% | General corrosive service, process piping |
| ASTM A213 | Seamless and welded austenitic tube | Minimum wall, zero plus / 20% minus | Heat exchanger, condenser, superheater |
| ASTM A249 | Welded austenitic tube | Minimum wall basis | Heat exchanger, feedwater heater |
TC1 vs TC2 in one line: EN 10216-5 TC1 is basic inspection with limited non-destructive testing, while TC2 requires 100 percent full-length automatic ultrasonic or eddy current scanning of every tube. The category must be stated in the purchase order.
Field judgement: over the past five years of reviewing rejected shipments for buyers, the root cause is almost never a mill defect but a purchase order that named a trade name instead of a specification, leaving mill, inspector and buyer each working to a different document.
A rejected container costs freight both ways, several weeks of schedule and a non-conformance report that follows the supplier through future tenders. Getting the purchase order clause right costs hours of engineering review. For importers building long-term relationships in oil and gas, power generation and petrochemical processing, matching specification to application is a commercial advantage.
TC1 is basic inspection with limited non-destructive testing. TC2 requires 100 percent full-length automatic ultrasonic or eddy current scanning of every tube. The inspection category must be stated in the purchase order.
Because the wall thickness basis differs. A312 uses average wall with plus or minus 12.5 percent, while A213 uses minimum wall. The same tube can be thinner at its thinnest point than the A213 minimum, so it cannot substitute for heat exchanger tube.
No. A312 does not mandate a 3.1 certificate by itself. European buyers must specify EN 10204 3.1 with heat number correlation directly in the purchase order.
About the supplier. Yuhong Group, established in 2007, supplies stainless steel seamless pipe and tube, heat exchanger tube and nickel alloy tube in ASTM, EN and JIS specifications from a single production base employing up to 850 people. Export markets account for 80-90 percent of turnover, and third-party inspection by SGS, BV or TUV is available on request with EN 10204 3.1 certification supplied as standard on request.
![]()
![]()
![]()
Contact Person: Mr. Jikin Cai
Tel: +86-13819835483
Fax: 0086-574-88017980