Yuhong Holding Group Co.,LTD
|
|
Steel Pipe vs Steel Tube: The Standard Decides, Not the Shape Buyers and traders usually separate steel pipe from steel tube by shape, material or cost. In practice the decisive factor is the ASTM / ASME standard the product is manufactured to. The welding engineering community states it plainly: ... Read More
|
|
|
One Grade Change, Two Years of Delay Offshore and sour gas projects often specify duplex stainless steel as a single line item: "duplex seamless pipe, UNS S31803 / S32205". That shorthand conceals a decision that determines whether a flowline survives twenty years of chloride-rich seawater or fails ... Read More
|
|
|
The Demand Shift Behind the Alloy Shortage Nickel alloy tube used to be a specialist line item ordered in small quantities for problem service. That has changed. The simultaneous build-out of LNG liquefaction capacity, hydrogen electrolyser plants, ammonia cracking units and low-sulphur refinery ... Read More
|
|
|
Why the Same Tube Arrives With Two Different Verdicts Every year, containers of stainless steel tube are rejected at destination for a reason that has nothing to do with quality: the material was manufactured to one specification and inspected against another. The buyer ordered 316L heat exchanger ... Read More
|
|
|
Duplex and Nickel Alloy Tube Selection Published by Yuhong Group Seamless Tube Engineering Team · Reviewed for project use · Last updated 9 November 2026 These notes record the variables our engineering team checks when reviewing duplex stainless steel and nickel alloy tube enquiries, and the ... Read More
|
|
|
Two Standards, One Family, Very Different Duties ASTM A179 and ASTM A192 are both seamless cold-drawn carbon steel tube standards built on the same low-carbon chemistry, and most mills — Yuhong Group included — routinely produce dual-certified A179/A192 heats. They are still not interchangeable in a ... Read More
|
|
|
Why the “3.1 or 3.2” Question Decides Your Lead Time Nearly every stainless tube enquiry ends with the same line: “inspection certificate to EN 10204 3.1” — or, less often, “3.2”. The documents look almost identical: same letterhead, same chemistry, same mechanical results. The difference is who ... Read More
|
|
|
Why This Question Comes Up in Every Second Inquiry An RFQ for “stainless steel tube” only becomes a real enquiry once the standard is fixed. ASTM A213, A269 and A312 carry the same TP304 and TP316 chemistry, yet they were written for different equipment, test regimes and levels of quality assurance. ... Read More
|
|
|
Two Frameworks, One Metallurgy European buyers specify stainless tube to EN 10216-5; American and Middle East projects specify the same steel to ASTM A213. The metallurgy is often identical, but grade designation, delivery condition, testing category and dimensional tolerances are documented under ... Read More
|
|
|
A Middle East distributor recently took delivery of four ASTM A269 TP316 seamless tube sizes for a coastal project where chloride exposure governs material selection — a reference point for buyers verifying what a mill delivers on A269 TP316: heat traceability, NDT regime, and documents that clear ... Read More
|